Mitsui Link Lab Shinkiba 2

Access

Address: 1-17-8, Shinkiba, Koutou-ku, Tokyo
googlemap

Access: [Tokyo Metro Yurakucho Line, Rinkai Line, JR Keiyo Line]
7 minutes walk from Shinkiba Station

Route map

Appearance photo

Overview of the building

Total leased area: 14,588m2 (approximately 4,413 tsubo)
Date of opening: April, 2023
Floor height: 4,500mm
Tenko: CH=3,000mm
Floor load: 1,000kg/m2 (1st floor)
500kg/m2 (2nd to 4th floors)
Draft chamber Whether or not to install: Allowed
Water supply and drainage facilities: Yes
City gas: Yes (reservation required)
Electric capacity: Single phase 100/200V: 200VA/㎡
Three phases 200V: 100VA/㎡
Emergency power generation: Yes: Single phase (three phases require consultation)
Parking lot: 35 parking spaces (including for persons with disabilities)

※The information provided is subject to change in the future.

Floor plan

A total of 112 sections that flexibly correspond to a maximum of about 4,000m2 on a floor from a minimum of about 73m2 on a floor.

1st floor plan

Base floor plan

About the exclusive department

Wet lab specification for all sections BSL2.
In addition, there is also a space that is easy for startups to move in.

73 to 99m2 parcels are available. Pre-construction of outlets, partition work, local exhaust duct work, sink installation work. Fixtures, experimental equipment, etc. must be prepared by tenants.

About common areas

In addition to cafes, lounges, conference rooms, rooftop terraces, hydrophilic spaces, etc.
A well-equipped common facility that makes use of the sense of release on the ocean front.

Use of common equipment

Equipment with a lot of needs will be installed in the common equipment room to reduce the initial investment of residents.

1 image analyzer / 1 cell analyzer / 4 fluorescence microscope / 1 microplate reader / 1 real-time PCR / 2 microscope / 2 ultra microscopic spectrophotometer / 1 digital PCR