Location
Laboratory/Office
Mitsui Link Lab Kasai
Mitsui Link Laboratory No. 1 Mitsui Link Lab
Access
- Address
-
1-16-13, Kitakasai, Edogawa-ku, Tokyo
googlemap
- Access
- [Toei Shinjuku Line]
A 12-minute walk from Funabori Station (4 minutes by bus)
[Tokyo Metro Tozai Line]
9 minutes using Nishikasai Station bus
A 2-minute walk from the "Machikayaba" bus stop
Route map
Appearance photo
Building Overview
- Total rental area
- 2,248.71m2 (approximately 680.23 tsubo)
- Date of opening
- January, 2020
- Floor height
- 4,000mm
- Tentaka
- CH=2,600mm
- Floor load
- 400kg/㎡
- Draft chamber
Acceptance of installation - BSL1 plots: Only the circulation type can be installed.
BSL2 plots: Allowed - Water supply and drainage facilities
- Yes,
- City Gas
- No,
- Electric capacity
- Single-face 100/200V: 100VA/㎡
Phase III 200V: 100VA/㎡ - Emergency power generation
- No,
- Parking lot
- 10 flat units
※The information provided is subject to change in future.
※Please note that the number of parking lots is limited, and it may not be possible to secure a parking lot on this site.
Floor plan
Standard floor plan
Exclusive Department
Wet lab specification with a total of 21 sections, BSL2 compatible section and BSL1 compatible section.
About common areas
A full range of shared facilities such as lounges, conference rooms, dining rooms and shops.
※The fee may be charged separately from the rent. ※The picture is part of the picture.
