Mitsui Link Lab Kashiwanoha 1 | Mitsui’s Lab & Office
Location
Laboratory/Office

Home > Location list > Mitsui Link Lab Kashiwanoha 1

Mitsui Link Lab Kashiwanoha 1

Proximity to Japan's leading advanced medical facilities
A newly established rental lab facility in Kashiwa-no-ha

Access

Access map of Mitsui Link Lab Kashiwanoha 1
Address
6-6-2, Kashiwanoha, Kashiwa-shi, Chiba
googlemap
Access
Tsukuba Express
3 minutes by bus from Kashiwa-no-ha Campus Station (West Exit)
A 3-minute walk from the Mitsui Garden Hotel Kashiwa-no-ha Parkside (Customs Training Center) bus stop.
To the airport
Direct bus
Nine flights a day from "Kashiwanoha Campus" station 9 flights a day (Tobu 6 flights and 3 Keikyu)
1 flight a day from Kashiwa-no-ha Campus Station to Narita Airport.

Route map

Route map

Appearance photo

Appearance 1
Appearance 2

Building Overview

Total rental area
8,227.92m2 (approximately 2,488.94 tsubo)
Date of opening
November, 2021
Floor height
1st floor: 5,500mm
Reference floor: 4,600mm
Tentaka
1st floor: 3,000 mm (assumed)
Reference floor: 3,000mm (assumed ceiling height of straight ceiling)
2,600 mm (down ceiling on the common corridor side)
Floor load
1,000kg/m2 (1st floor)
500kg/m2 (base floor)
Draft chamber
Acceptance of installation
Some parcels are acceptable.
Water supply and drainage facilities
Yes,
City Gas
Yes,
Electric capacity
Single-face 100/200V:
250VA/m2 (of which 15VA/m2 is a security power supply)
Three-phase 200V:
・Standard floor, 1st floor (4 sections on the north side): 100VA/m2 (excluding air-conditioning)
・The first floor (5 sections on the south side): 250VA/m2 (including air conditioning)
Emergency power generation
Yes,
Parking lot
48 parking lots (including 40 cars for residents, 4 for visitors, 1 for wheelchair users), 10 motorcycles, 26 bicycles

※The information provided is subject to change in future.

Floor plan

A total of 75 parcels that can be flexible from a minimum of about 35m2 to a maximum of about 1,400m2.

1st floor plan

1st floor plan

Standard floor plan

Standard floor plan

3F floor plan

3F floor plan

Exclusive Department

Wet lab specifications compatible with all sections BSL2.
In addition, there is a section that makes it easier for startups to move in.
Exclusive Department on each floor
Exclusive Department on each floor
Exclusive Department on each floor
Exclusive Department on each floor
Blocks for startups (image)
Blocks for startups (image)

A space of about 40m2 is available. Prepare electrical outlets, partitions, and local exhaust duct work are performed in advance. All fixtures and equipment, experimental equipment, etc. must be prepared by the tenant.

About common areas

A full-fledged shared facility equipped with a cafe, lounge, conference room, etc., and is easy for people from surrounding research facilities to gather.
1st floor entrance
1st floor entrance
Meeting room on the first floor
Meeting room on the first floor
Communication lounge on the first floor
Communication lounge on the first floor
Café on the first floor
Café on the first floor
EV hall on each floor
EV hall on each floor
Common Equipment Room Lounge
Common Equipment Room Lounge

※The photo on this page is an image photo. It's not the actual one.

Use of common equipment

Equipment with many needs will be installed in the common equipment room to reduce initial investment by tenants.

2 image analyzers / 2 cellar analyzer / 2 fluorescent microplate reader / 2 microplate reader / 1 real-time PCR / 1 ultra trace spectrometer

Image analyzer
Image analyzer
Microplate reader
Microplate reader
Cellanalizer
Cellanalizer

Use of high-performance equipment from tenant companies (University of Tokyo)

The University of Tokyo, where you are currently moving in can use the equipment (NMR, LC-MS, etc.) in the link lab.

※The University of Tokyo is required to apply to the University of Tokyo.

※Please contact us if you have any questions.

Contact

Those who are looking for brochures

Requests for data

Those who want to know about previews and rents

Contact